|
 DOOR
CONSTRUCTION
• Extruded aluminum perimeter framing with steel sheets front
and back.
• Pressure injected with minimum 2.2 pounds per cubic foot of
polyurethane foam.
• Polyurethane foam bonds with sheets and frame to
make a seamless, rigid panel with minimum insulating value of R6.5.
• Thermal door uses a high density polyurethane thermal break.
MASTER FRAME CONSTRUCTION
 •
Frame is fabricated of commercial quality aluminum extrusions.
• Master frame is shipped completely assembled with hinges and
door attached.
• Thermal frame uses a high density polyurethane thermal break.
• Frame is prepared for installation into wall panel with .250
diameter holes through the installation flange of the top, bottom and
both vertical frame members.
• T Frame is used for inswing application.
• Z Frame is used for outswing application.
|
 |
Note: all downloads are in PDF format. If you
do not
have Adobe Acrobat Reader, Click
here for a free copy. |
|
GASKET
 •
AJ Manufacturing's proprietary Santoprene® gasket is
press-fitted
into frame for maximum air and water seal and is field replaceable.
DOOR HARDWARE
 •
Door panel is prepped with extruded aluminum
reinforcing blocks at all latch locations to provide
maximum strength and performance.
• Stainless steel hinges standard on all doors.
DOOR VIEWPORTS
• Insulated tempered glass in the following sizes:
- 8” x 8” View Area – Thermal pane
clear/clear, wire/clear or wire/wire
- 11” x 11” View Area – Thermal pane
clear/clear, wire/clear or wire/wire
• After-market viewports and reglazing kits are also available.
OPTIONS
• Thermal
• Galvanized
• Non-thermal
• Galvannealed
• Stainless 304 2B
• Windows
• Smooth aluminum
• Embossed aluminum
• Full-length hinges
• Outswing
• Inswing
PATENT
PENDING
|
